NEC NEAX 2000 Programming Manual page 136

Flat Rate/Fixed Charge Programming
When the battery reversal signal arrives as an answer signal or no answer signal, and when the
C.O. outgoing call charge with the flat rate is required, do the following programming.
START
CMD004 Assign the charging rate (Flat Rate) for Lo-
cal Call, Toll Call.
CMD026 Assign the charging method development
table number to outgoing trunk route.
Assign the charging method to each dialed
CMD027
digit.
END
DESCRIPTION
CALL INFORMATION SYSTEM (CIS)
(1) 40-49: Flat Rate No. 0-9
(2) 0 -9999: Charging rate
NOTE:
(1) 00-63: Trunk Route No.
(2) 000 -511: Development table No.
(1) XXX Y
XXX: 000-511: Development table No.
Y : 0-9, A (*), B (#): Dialed digit
(2) X Y
X: 0-9: Flat Rate No. assigned by
Y: 6: With answer signal
A: No answer signal
– 116 –
PROGRAMMING
Flat Rate/Fixed Charge Programming
DATA
In case of no charge (Free of
Charge), no data assignment
is required.
CMD004
A2107-10