NEC NEAX 2000 Programming Manual page 632

A
CM31
Assign the duration from sending start
Forward signal to receiving Backward sig-
nal, if required.
Assign the duration from detecting Back-
ward signal to receiving stop Backward
signal, if required.
CM08
Assign the connecting method when re-
ceiving Backward signal meaning Line
Busy/Unallocated number/Congestion.
Select whether the Sender Tone is sent or
not on DOD call.
Select whether the supervision of Pulse
Form signal is performed or not on DOD
call.
CM35 Specify the originating method (sender
start operation).
By setting the data to "1", you can quicken
the completion of the call origination.
END
DESCRIPTION
INITIAL
INITIAL
INITIAL
FEATURES FOR OTHER COUNTRIES ONLY
MFC-INCOMING CALL/MFC-OUTGOING CALL
Y=B
•
(1) 00
(2) 01-31
NONE : 12 sec.
Y=B
•
(1) 01
(2) 01-31
NONE : 12 sec.
(1) 473
(2) 0/1
NOTE 1
(1) 475
(2) 0/1
NOTE 1
(1) 478
(2) 0/1
NOTE 1
NOTE 1:
Y=36
•
(1) 00-63: Trunk Route No.
(2) 0 : Originated after the last digit is di-
aled
1 : Originated without waiting until the
last digit is dialed
– 612 –
DATA
: 1 sec.-31 sec.
: 1 sec.-31 sec.
Refer to the "MFC Data As-
signment Table for Each
page 615
Country".
A2594-10