NEC NEAX 2000 Programming Manual page 47

A
CM49 Assign the function of the Digital An-
nouncement Trunk card.
Assign the Digital Announcement Trunk as
CM51
the destination of the DID call on each ten-
ant.
Assign the Digital Announcement Trunk as
the destination of the Tie Line call on each
tenant.
To record, replay and delete a message,
CM20
assign the Digital Announcement Trunk
access code respectively.
END
Announcement Service can be used to provide a voice message when an incoming
NOTE:
DID line/Tie line call has been terminated to a station and encounters a busy or no an-
swer condition. After the voice message is given, normal call processing continues.
This application can be programmed on a tenant basis.
•
Only one (1) message of up to the following seconds can be recorded on an individ-
•
ual Digital Announcement Trunk Card.
Built-in DAT on MP: 120 sec.
4DAT card: 120 sec.
DESCRIPTION
Y=00
•
(1) 000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk
(2) 0D00: No Answer
0E00: Busy
Y=00 No Answer
•
Y=03 Busy
•
(1) 00-63: Tenant No.
(2) EB000-EB127: Digital Announcement
Y=01 No Answer
•
Y=04 Busy
•
(1) 00-63: Tenant No.
(2) EB000-EB127: Digital Announcement
Y=0-3 Numbering Plan Group 0-3
•
(1) X-XXXX: Access Code
(2) A100: Record
A101: Replay
A102: Delete
– 27 –
ANNOUNCEMENT SERVICE
DATA
Card No. (EB002-EB127) as-
signed by CM10
Trunk No.
Trunk No.
A2018-10