NEC NEAX 2000 Programming Manual page 933

DIRECT STATION SELECTION (DSS) CONSOLE
GENERAL DESCRIPTION
This feature allows a DIRECT STATION SELECTION (DSS) CONSOLE to be associated with a
term
D . When the keys on the DSS CONSOLE are programmed for DSS keys, up to 60 stations can be
directly accessed in addition to those already appearing on the D
cated by a red LED associated with each key.
In addition, the DSS CONSOLE can provide the following functions:
• MESSAGE WAITING - Set/Cancel/Status Display
• DO NOT DISTURB - Set/Cancel/Status Display
• AUTOMATIC WAKE UP No Answer - Status Display/Cancel
• AGENT BUSY OUT - UCD - Status Display
• LINE LOCKOUT - Status Display
• ROOM CUTOFF - Set/Cancel/Status
STATION APPLICATION
term
All D s
OPERATING PROCEDURE
To initiate a call:
1. Press the desired DSS key,
2. Lift the handset and converse when the party answers.
OR
1. Lift the handset and receive Dial Tone.
2. Press the desired DSS key.
3. Converse when the party answers.
To display LINE LOCKOUT status:
1. No manual operation is required.
When stations are currently in LINE LOCKOUT mode, their associated LED will flash red at 30
ipm.
SERVICE CONDITIONS
term
1. A D can be equipped with as many DSS CONSOLE units as necessary.
2. The amount of DSS CONSOLE is limited to 8 units for every Firmware Processor (FP) installed, for a
system total of 32 units.
(DSS + ADD-ON MODULE)
3. A maximum of 60 DSS keys can be assigned on each DSS CONSOLE.
4. When a call is made using the DSS CONSOLE, the LCD of associated D
tion that is provided for internal calls made from the line keys of the D
term
ND-91285-001(E)
DECEMBER, 1999
. Busy status for each station is indi-
term
displays the same indica-
term
.
Revision 1.0
(1/6)
Page 151