NEC NEAX 2000 Programming Manual page 897

GENERAL DESCRIPTION
This service feature allows an Attendant to change incoming C.O. terminating method on either mode
of day and night according to necessity while the system is operating on line mode.
The change of day and night mode can be performed by depressing NIGHT key on Attendant Console.
STATION APPLICATION
All stations
OPERATING PROCEDURE
To change incoming C.O. terminating method from DESK CONSOLE:
1. Depress idle LOOP key.
2. Dial feature access code for CHOICE OF NIGHT SERVICE.
3. Dial "0".
4. Dial 0/1 + XXX .
Day/Night Trunk No.
5. Depress ANSWER key.
Display XXX
Trunk No. Existing Data of incoming C.O.
6. Dial XX + XXX .
incoming C.O. Trunk No.
terminating method code (Note)
7. Depress START key.
8. With the same operation from 4 performed, it can be continuously changed every Trunk Number.
To change incoming C.O. terminating method from SMART CONSOLE:
1. Depress idle LOOP key.
2. Depress PROG key.
3. Dial password (1-8 digit(s)).
4. Depress CHN/S (CHOICE OF NIGHT SERVICE) key.
5. Dial 0/1 + XXX .
Day/Night
6. Dial incoming C.O. terminating method code (Note)
7. Depress ANS key.
8. Depress CNCL key.
9. With the same operation from 6 performed, it can be continuously changed every Trunk Number.
CHOICE OF NIGHT SERVICE
XX
terminating method
Trunk No.
ND-91285-001(E)
DECEMBER, 1999
(1/2)
Page 115
Revision 1.0