NEC NEAX 2000 Programming Manual page 958

(1/1)
GENERAL DESCRIPTION
This feature forces the user to enter an ACCOUNT CODE (up to 8 or 10 digits) for all outgoing calls.
The ACCOUNT CODE must be dialed before dialing the outgoing number. Calls are processed only when
the dialed ACCOUNT CODEs are valid.
STATION APPLICATION
All stations
OPERATING PROCEDURE
When dialing an outgoing call:
1. Lift the handset and receive Dial Tone.
2. Enter the FORCED ACCOUNT CODE feature access code and receive Service Set Tone.
3. Enter the FORCED ACCOUNT CODE (up to 8 or 10 digits) and receive Dial Tone.
4. Dial the desired number.
SERVICE CONDITIONS
1. The maximum number of digits in the FORCED ACCOUNT CODE is programmable, (for the entire
system), from 1 to 8 or 10 digits.
2. The FORCED ACCOUNT CODE access code can be 1 to 3 digits.
3. FORCED ACCOUNT CODE Limitations
a. In the case of a system with AP01 card
• Number of digits: 1 digit - 10 digits (If Check Code is provided, limited to 8 digits)
The same number of digits must be assigned to AUTHORIZATION CODE and FORCED
ACCOUNT CODE.
• Number of codes: Up to 1,000 codes combined with AUTHORIZATION CODE and REMOTE
ACCESS CODE.
b. In the case of a system without AP01 card
• Number of digits: 1 digit - 8 digits
• Number of codes: The maximum number of codes depends on the numbering scheme and digit
number. For details, refer to APPENDIX 3.
4. Both AUTHORIZATION CODE and FORCED ACCOUNT CODE can be provided for the same sys-
tem.
5. Stations are assigned this feature according to CLASS OF SERVICE programming in system data.
6. FORCED ACCOUNT CODEs are recorded in the STATION MESSAGE DETAIL RECORDING
(SMDR).
7. Existing restriction assignments will be applied even after a FORCED ACCOUNT CODE is entered.
8. A FORCED ACCOUNT CODE can be assigned per a station number so that one code is used only on
the specific station. Application Processor (AP01) is required.
Page 176
Revision 1.0
FORCED ACCOUNT CODE
ND-91285-001(E)
DECEMBER, 1999