NEC NEAX 2000 Programming Manual page 801

ATTENDANT CAMP-ON WITH TONE INDICATION
GENERAL DESCRIPTION
This service feature permits the Attendant, when a desired station is busy, to hold an incoming call in a
special waiting mode. The Attendant sends a distinctive CAMP-ON WITH TONE INDICATION to the
busy station. When that station becomes idle, it is automatically rung and connected to the waiting trunk
party upon answering.
STATION APPLICATION
DESK CONSOLE
SMART CONSOLE
OPERATING PROCEDURE
To activate CAMP-ON from the Attendant:
1. Dial the desired station number; receive Busy Tone.
2. Press RELEASE key; CAMP-ON tone is sent to the busy station and CAMP-ON is set.
To cancel CAMP-ON from the Attendant:
1. Press LOOP key corresponding to held call; connect to the waiting trunk party.
2. Press DEST key; receive Busy Tone.
3. Press CANCEL key; automatically returned to the trunk party.
To reenter the call that has been CAMPED-ON from the Attendant before being recalled:
1. Press the LOOP key corresponding to held call.
2. The busy station number and name are displayed for six seconds in the left side of the console's
display. (For SMART CONSOLE only if provided by system data)
3. Converse with the held party.
OR
1. Dial the CALL PICKUP-DIRECT feature access code; receive Special Dial Tone.
2. Dial the station number of desired busy station.
3 Converse with the held party.
To answer ATTENDANT CAMP-ON:
From a Single Line Telephone:
1. Receive CAMP-ON Tone.
2. Hang up and receive incoming ring (existing call is abandoned).
3. Lift the handset and converse.
OR
1. Receive CAMP-ON Tone.
2. Press FLASH key (or momentarily depress hookswitch). The call in progress is placed on
CONSULTATION HOLD.
3. Dial the CALL HOLD feature access code. The original call is placed on hold and the station
user is automatically connected to the CAMP-ON call.
ND-91285-001(E)
DECEMBER, 1999
(1/2)
Page 19
Revision 1.0