NEC NEAX 2000 Programming Manual page 812

(1/2)
ATTENDANT SPEED CALLING- SYSTEM SET UP
GENERAL DESCRIPTION
This service feature allowed the Attendant and is used to SPEED CALLING-SYSTEM SET UP oper-
ation.
STATION APPLICATION
All stations
OPERATING PROCEDURE
To set up the SPEED CALLING-SYSTEM:
1. Depress the idle LOOP key.
2. Depress the PROG key.
The PROG key LED (red) lights.
"PASSWORD" is displayed on the LCD as prompt information.
3. Dial the password (1-8 digits).
The dialed password is displayed on the LCD.
When the password dialing is completed, the PROG key LED (red) blinks at this time.
If the RLS key is depressed in this status, the Attendant Console can go back to the idle status.
At this time, both CANCEL and ANS keys are invalid.
After the above operation, select; SPD operation.
4. Depress the SPD key.
The SPD key LED (red) comes on.
5. Dial the block # (5 digits).
The selected block number is displayed as follows along with the currently registered trunk access
code and telephone number.
000012..........0-
12345............56
SPD
6. Dial the new trunk access code to register.
If there is no change, skip to step 4.
7. Depress the ANS key.
8. Dial the new telephone number.
If there is no change, skip to step 6.
9. Depress the ANS key.
The new access code and the telephone number are set up.
10. Depress the CNCL key.
To program another block number, return to step 2.
11. Depress the CNCL key.
The system goes back to the status assumed after the password was set.
Page 30
Revision 1.0
ND-91285-001(E)
DECEMBER, 1999