A
Assign the function for each Digital An-
CM49
nouncement Trunk card.
CM20
To record, replay and delete a message,
assign the respective Digital Announce-
ment Trunk access code.
END
Announcement Service can be used to provide a voice message when an incoming
NOTE:
C.O. line/Tie line call has been transferred and encounters a busy or no answer condi-
tion. After the voice message is given, normal call processing continues.
This application can be programmed on a tenant basis.
•
Only one (1) message of up to the following seconds can be recorded on an individ-
•
ual Digital Announcement Trunk Card.
Built-in DAT on MP: 120 sec.
4DAT card: 120 sec.
In this application, a minimum of two Digital Announcement Trunk Circuits are need-
•
ed, one for busy condition, and one for no answer.
More than one Digital Announcement Trunk Circuit can be used, depending on traffic
•
conditions.
System programming can be set to, wait until circuit(s) become free or immediately
•
follow preprogrammed normal call handling, if a busy condition is encountered.
Digital Announcement Trunk Circuits can be shared among tenants.
•
This feature does not function on Attendant transferred calls.
•
DESCRIPTION
Y=00
•
(1)
000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk
(2)
06XX: No Answer
XX
: 00-63: Message No.
07XX: Busy
XX
: 00-63: Message No.
Y=06 No Answer
•
Y=07 Busy
•
(1)
XX: 00-63: Tenant No. of transferring
(2)
XX: 00-63: Message No. assigned by
Y=0-3 Number Plan Group 0-3
•
(1)
X-XXXX: Access Code
(2)
A100: Record
A101: Replay
A102: Delete
– 25 –
ANNOUNCEMENT SERVICE
DATA
Card No. (EB002-EB127) as-
signed by CM10
station
Y=00
A2018-10