Message Registration - NEC NEAX 2000 Programming Manual

MESSAGE REGISTRATION

PROGRAMMING
The SMDR is used to provide Message Registration information to a call accounting system.
Refer to STATION MESSAGE DETAIL RECORDING (SMDR).
To provide Message Registration on PMS:
START
CM08 Provide the system with SMDR service for
tandem calls.
Assign the Pseudo-Answer signal function
when the answer signal (Battery Reversal)
has not been detected within the time as-
signed by CM41 Y=0>03 after making an
outgoing trunk call.
This data is effective when CM35
NOTE:
Y=04 is set to "1".
Provide SMDR service for outgoing calls
CM13
to required stations.
Provide SMDR service for incoming calls
to required stations.
CM35 Specify the type of answer signal from dis-
tant office in outgoing connection for each
trunk route.
Provide SMDR service for outgoing calls
to required trunk routes.
A
DESCRIPTION
(1) 040
(2) 0: Available
(1) 123
(2) • For Australia
0 : To send
1 : Not sent
• For other countries
0 : Not sent
1 : To send
Y=06
•
(1) X-XXXX: Station No.
(2) 1 : To provide
Y=05
•
(1) X-XXXX: Station No.
(2) 0 : To provide
1 : Not provided
Y=04
•
(1) 00-63: Trunk Route No.
(2) 2 : Answer signal arrives from Tie
Line/ISDN
7 : Answer signal does not arrive
Y=14
•
(1) 00-63: Trunk Route No.
(2) 1 : To provide
– 676 –
MESSAGE REGISTRATION
page 477
DATA
A2668-10