Code Calling Access - NEC NEAX 2000 Programming Manual

CODE CALLING ACCESS

PROGRAMMING
START
CM10
Assign the interface trunk (COT card and
DK card) to the required LEN.
NOTE 1: The DK card number must be as-
signed to the first LEN (Level 0)
and the third LEN (Level 2) of
each LT slot.
Assign the trunk data to the trunk number.
CM30
Assign the route data to the trunk route
CM35
specified by CM30 Y=00.
A
DESCRIPTION
(1) 000-763: LEN
(2) D000-D255: COT Card No.
E800-E831: DK Card No.
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE 2:
Y=0 Trunk Route Allocation
•
(1) 000-255: Trunk No.
(2) 00-63: Trunk Route No.
Dedicated route number for this service
should be assigned.
Y=01 Tenant Allocation
•
(1) 000-255: Trunk No.
(2) 00, 01 -63: Tenant No.
Y=00 Kind of Route
•
(1) 00-63: Trunk Route No.
(2) 05
Y=01 Type of Signal to be sent out
•
(1) 00-63: Trunk Route No.
(2) 2: DP
4: DTMF
Y=08 Dial Pulse Sending
•
(1) 00-63: Trunk Route No.
(2) 3 : To send
– 152 –
CODE CALLING ACCESS
DATA
Circuit No. 3 of E831 is used
for built-in External Equip-
ment Interface of MP card by
setting CM44.
A2148-10