NEC NEAX 2000 Programming Manual page 106

A
CM90
Assign Call Forwarding-Busy Line keys to
term
the D , as required.
CM35 To apply this feature to incoming call, set
up the combination of trunk routes for Tan-
dem Connection.
For Resident System Program-
CM36 NOTE:
ming, refer to the Command
Manual.
CM08 Specify the setting method for Call For-
warding-Busy Line-Outside.
CM65 Provide Call Forwarding feature with each
tenant as per incoming call type.
B
DESCRIPTION
CALL FORWARDING-BUSY LINE
CALL FORWARDING-BUSY LINE-D
CALL FORWARDING-BUSY LINE-OUTSIDE
Y=00
•
(1) My Line No. +
(2) F0014: Call Forwarding-Busy Line Set/
For setting the same key as Call Forward-
ing-Don't Answer
(2) F0012: Set/Cancel
Y=05
•
(1) 00-63: Trunk Route No.
(2) 1 : Release Signal arrives
Y=0
•
(1) Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
(2) 0: Allow
(1) 222
(2) 0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
Y=23 Internal Call or ATT assisted call
•
Y=24 C.O. Incoming Call
•
Y=25 Tie Line Incoming Call
•
(1) 00-63: Tenant No.
(2) 1 : Call Forwarding
– 86 –
DATA
,
+ Key No.
Cancel
term
NOTE
NOTE
A2076-10