NEC NEAX 2000 Programming Manual page 484

A
CM20 Assign the access code for Split Call For-
warding-Don't Answer.
To apply this feature to incoming calls, as-
CM35
sign the combination of trunk routes for
Tandem Connection.
CM36
CM41
Specify the timing for Call Forwarding-
Don't Answer for a trunk incoming call.
Specify the timing for Call Forwarding-
Don't Answer for an internal call or an as-
sisted call.
Specify the setting method for Call For-
CM08
warding-Don't Answer-Outside.
Assign whether or not an extension can
set Split Call Forwarding-Don't Answer-
Outside by entering only a trunk access
code.
B
DESCRIPTION
SPLIT CALL FORWARDING-DON'T ANSWER
(1) X-XXXX: Access Code
(2) A182: Split Call Forwarding-Busy Line/
-Don't Answer Entry
A183: Split Call Forwarding-Busy Line/
-Don't Answer Cancel
Y=05
•
(1) 00-63: Trunk Route No.
(2) 1 : Release Signal arrives
Y=0
•
(1) Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
(2) 0: Allow
Y=0
•
(1) 01
(2) 01-30: 4 sec.-120 sec.
If no data is set, the default setting is 32-36
sec.
Y=0
•
(1) 15
(2) 01-30: 4 sec.-120 sec.
If no data is set, the default setting is 32-36
sec.
(1) 222
(2) 0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
(1) 386
(2) 0 : Restricted
1 : Allow
– 464 –
DATA
(4 sec. increments)
(4 sec. increments)
A2463-10