Trunk To Trunk Connection - NEC NEAX 2000 Programming Manual

TRUNK TO TRUNK CONNECTION

PROGRAMMING
START
CM12 Assign the Service Restriction Class C to
each station.
Provide the switch hook flash capability
CM15
during C.O. line connection in the Service
Restriction Class C assigned by CM12
Y=07.
Specify the combination of trunk routes al-
CM36
lowing the Trunk to Trunk Connection.
Provide the system with Ring Transfer for
CM08
Call Transfer-All Calls to a trunk when a
station holds another station or trunk.
Provide the system with forced release
when a tandem call duration passes a pre-
determined time.
Allow or restrict forced release of tandem
CM35
connection for the incoming trunk route.
This data is available when CM08>029 is
set to 0.
Specify the forced release timing for tan-
CM41
dem call.
A
DESCRIPTION
TRUNK TO TRUNK CONNECTION
Y=07
•
(1) X-XXXXXXXX: My Line No.
(2) 00-15 : Service Restriction Class C
Y=90, 91
•
(1) 00-15: Service Restriction Class C as-
(2) 1 : Allow
Y=0
•
(1) XX ZZ
XX: 00-63: Incoming trunk route
ZZ: 00-63: Outgoing trunk route
(2) 0 : Allow
1 : Restricted
(1) 253
(2) 0: Available
(1) 029
(2) 0 : To disconnect
1 : To continue
Y=119
•
(1) 00-63: Trunk Route No.
(2) 0 : Allow
1 : Restricted
Y=0
•
(1) 54
(2) 01-06: 64 min.-224 min.
If no data is set, the default setting is 96-128
min.
– 540 –
DATA
signed by CM12 Y=07
(32 min. increments)
A2536-10