NEC NEAX 2000 Programming Manual page 465

(2) To provide the One Touch key to send "Hooking Signal + Called Number" to a Centrex, set
the following data in addition to the programming (1).
START
CM20
Assign the access code for sending of a
Hooking signal to a Centrex.
Maximum of two digits are available.
Assign a RECALL key on the D
CM90
RECALL key is used to return to a former
line.
CM35 Provide the Centrex trunk route with
Centrex function.
END
(3) To provide the One touch key to send "Called Number + DTMF Signal" for such as VMS
operation, set the following data in addition to the programming (1), when the called number
includes a trunk access code. If the called number includes no trunk access code, this data
is not required.
START
CM08
Specify whether to set consecutive dialing
"*#" as a delimiter between the called num-
ber and the DTMF signal.
END
HARDWARE REQUIRED
term
D with One Touch key and DLC card
DESCRIPTION
term
.
DESCRIPTION
– 445 –
SPEED CALLING-ONE TOUCH-D
DATA
Y=0-3
•
(1) X-XXXX: Access code
(2) A158: Hooking signal to a Centrex
Y=00
•
,
(1) My Line No. + + Key No. (90)
(2) F1015: RECALL
Y=86
•
(1) 00-63: Trunk Route No.
(2) 0: Centrex
DATA
(1) 448
(2) 0 : *# set as dialed digit
1 : Delimiter between called number
and DTMF signal
term
A2437-10