NEC NEAX 2000 Programming Manual page 546

B
CM35
According to the characteristics of each
C.O. line, assign the data for DP/DTMF
Sender to each Route.
For details of the command, refer to
"COMMAND MANUAL".
CM41 Specify the timing for ORT Timeout on
Outgoing C.O. Call.
Assign the access code to each route.
CM20
Assign the maximum number of sending
CM85
digits dialed after C.O. access code.
END
HARDWARE REQUIRED
COT card
DESCRIPTION
TOLL RESTRICTION-TOTAL DIGIT COUNT
Y=20 Sender Start Condition
•
Y=21 Sender Prepause Timing
•
Y=23 DP-Inter Digital Pause
•
Y=24 DTMF-Inter Digital Pause
•
Y=25 DP-Make Ratio
•
Y=26 DTMF Signal Width
•
Y=45 DP Sender Release Timing
•
Y=46 DTMF Sender Release Timing
•
Y=0
•
(1) 27
(2) 03-14: 3 sec.-14 sec.
If no data is set, the default setting is 7 sec.
Y=0-3 Numbering Plan Group 0-3
•
(1) X-XXXX: Access Code
(2) 100-163: Trunk Route No. 00-63
Y=0-7 Area Code Analysis Group
•
(1) Area/Office Code (1-8 digits)
(2) Maximum number of sending digits
(1-24 digits)
NOTE:
– 526 –
DATA
(1 sec. increments)
For unassigned office code by
this command, the maximum
number of sending digits is
automatically set to "24".
A2523-10