Flash Over Trunk; Flash Over Trunk-D Term - NEC NEAX 2000 Programming Manual

FLASH OVER TRUNK

FLASH OVER TRUNK-D
PROGRAMMING
In addition to the programming of "DIRECT OUTWARD DIALLING"
ing programming.
START
CM35 Assign the dialing signal type (call origina-
tion) to the distant PBX to the route num-
ber assigned by CM30 Y=00.
Assign the data for the hooking signal
sending to outside to the route number as-
signed by CM30 Y=00.
Assign the DTMF Signal Width, if the data
of CM35 Y=01 is 4 or 7, to the route num-
ber assigned by CM30 Y=00.
CM41 Specify the duration of hooking signal to
outside.
Assign the Switch Hook Flash key for
CM90
sending hooking signal to outside on a
term
D , if required.
Assign the Flash Over Trunk key on the
ATTCON/DESKCON.
END
HARDWARE REQUIRED
term
D and DLC card if required
term
DESCRIPTION
Y=01
•
(1) 00-63: Trunk Route No.
(2) 2 : DP (10 PPS)
3 : DP (20 PPS)
4 : DTMF
7 : DTMF
Y=16
•
(1) 00-63: Trunk Route No.
(2) 1 : Sending
Y=26
•
(1) 00-63: Trunk Route No.
(2) 0 : 64 ms.
1 : 128 ms.
Y=2
•
(1) 17
(2) 02-30: 128 ms.-1920 ms.
If no data is set, the default setting is 576-
640 ms.
Y=00
•
(1) My Line No. +
(2) F1009
Y=00
•
(1) ATTCON No. (E000-E007) +
No.
(2) F6106
– 258 –
FLASH OVER TRUNK
FLASH OVER TRUNK-D
page 227 , do the follow-
DATA
(64 ms. increments)
,
+ Key No.
term
,
+ Key
A2247-10