NEC NEAX 2000 Programming Manual page 973

GENERAL DESCRIPTION
This service feature permits access to an individual trunk within a trunk group via dial access at the
Attendant Console and station.
STATION APPLICATION
All stations
DESK CONSOLE
SMART CONSOLE
OPERATING PROCEDURE
To access from Attendant Console:
1. Depress an idle loop.
2. Dial feature access code (max. 3 digits).
3. Dial trunk identification number or C.O. code number (4 digits).
4. If trunk is idle, Dial Tone will be received.
To access from station:
1. Lift hand set; receive Dial Tone.
2. Dial feature access code (max. 3 digits).
3. Dial trunk identification number or C.O. code number (4 digits).
4. If trunk is idle, Dial Tone will be received.
SERVICE CONDITIONS
1. A digital display will appear on the Attendant Console which will consist: C.O. code number.
2. If the trunk is busy, the Attendant or station will receive Busy Tone.
3. The Attendant can utilize ATTENDANT OVERRIDE, if it is included in system programming, to gain
entry into a particular trunk when it is in use.
4. If the trunk is make busy status, either by software control, the Attendant can still access that trunk
using the above mentioned operating procedure.
5. Paging trunks cannot be accessed by this feature.
INDIVIDUAL TRUNK ACCESS
ND-91285-001(E)
DECEMBER, 1999
(1/1)
Page 191
Revision 1.0