NEC NEAX 2000 Programming Manual page 907

CUSTOMER ADMINISTRATION TERMINAL (CAT)
GENERAL DESCRIPTION
By a key entry from a D
(CAT) mode. Then, the office data can be changed or displayed from that D
STATION APPLICATION
term
All D s with an LCD
OPERATING PROCEDURE
Refer to the Command Manual.
SERVICE CONDITION
1. There is no limitation to the number of D
term
2. The number of D
ited to max. two sets.
3. The CAT can be operated only while the PBX is on-line status.
4. Two commands 'CM00' (Office Data All Clear) and 'CM01' (Office Data Partial Clear) cannot be
used on the CAT.
5. When starting up the system only by the CAT (without MAT), the CAT should be made valid first by
starting up using the standard office data, and then the intended office data can be changed.
6. The office data which can be changed/added from the CAT can be limited by password.
term
7. The D which can be used as CAT is limited to a set equipped with LCD.
term term
, the D can be set to CUSTOMER ADMINISTRATION TERMINAL
term
s which can be set to CAT mode.
s which can be concurrently set to CAT mode for handling the office data is lim-
ND-91285-001(E)
DECEMBER, 1999
(1/1)
term
.
Page 125
Revision 1.0