NEC NEAX 2000 Programming Manual page 104

A
CM36
Specify the setting method for Call For-
CM08
warding-All Calls-Outside.
Assign whether or not an extension can
set Call Forwarding-All Calls-Outside by
entering only a trunk access code.
Assign whether or not the system should
check the trunk restriction class of the for-
warded station during a Call Forwarding-
All Calls-Outside.
CM65 Provide Call Forwarding feature with each
tenant as per incoming call type.
CM48 Select the Dial Tone on setting Call For-
warding-All Calls.
END
HARDWARE REQUIRED
term
D and DLC card if required
DESCRIPTION
INITIAL
CALL FORWARDING-ALL CALLS
CALL FORWARDING-ALL CALLS-D
CALL FORWARDING-ALL CALLS-OUTSIDE
Y=0
•
(1) Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
(2) 0: Allow
(1) 222
(2) 0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
(1) 386
(2) 0 : Restrict
1 : Allow
(1) 387
(2) 0 : Call forwarding All Calls-Outside
follows setting station class
1 : No check
Y=23 Internal Call or ATT assisted Call
•
Y=24 C.O. Incoming Call
•
Y=25 Tie Line Incoming Call
•
(1) 00-63: Tenant No.
(2) 1 : Call Forwarding
Y=2
•
(1) 13: Dial Tone on Setting Call Forward-
ing-All Calls
(2) 0 : Special Tone
1 : Dial Tone
– 84 –
term
DATA
A2076-10