NEC NEAX 2000 Programming Manual page 109

A
CM90 Assign Call Forwarding-Don't Answer keys
term
to the D , as required.
Specify the timing for Call Forwarding-
CM41
Don't Answer for a trunk incoming call.
Specify the timing for Call Forwarding-
Don't Answer for an internal call or an as-
sisted call.
To apply this feature to incoming calls, as-
CM35
sign the combination of trunk routes for
Tandem connection.
CM36 For Resident System Program-
NOTE:
ming, refer to the Command
Manual.
CM08 Specify the setting method for Call For-
warding-Don't Answer-Outside.
B
DESCRIPTION
CALL FORWARDING-DON'T ANSWER
CALL FORWARDING-DON'T ANSWER-D
CALL FORWARDING-DON'T ANSWER-OUTSIDE
Y=00
•
(1) My Line No. +
(2) F0016: Call Forwarding-Don't Answer
For setting the same key as Call Forward-
ing-Busy Line
(2) F0012: Set/Cancel
Y=0
•
(1) 01
(2) 01-30: 4 sec.-120 sec.
(4 sec. increments)
If no data is set, the default setting is 32-36
sec.
Y=0
•
(1) 15
(2) 01-30: 4 sec.-120 sec.
(4 sec. increments)
If no data is set, the default setting is 32-36
sec.
Y=05
•
(1) 00-63: Trunk Route No.
(2) 1 : Release Signal arrives
Y=0
•
(1) Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
(2) 0: Allow
(1) 222
(2) 0 : The feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : The feature is set when receiving
Service Set Tone (ORT time out)
– 89 –
DATA
,
+ Key No.
Set/Cancel
term
NOTE
NOTE
A2088-10