NEC NEAX 2000 Programming Manual page 570

To provide the call waiting lamps on the D
START
Assign the incoming call to queuing mode
CM08
when all UCD stations are busy.
Specify the maximum number of queuing
CM42
in each UCD group for controlling call wait-
ing lamp of D
Depending on the number of
NOTE:
queuing station/trunk, lamp indi-
cation pattern on D
ent as shown below:
N=Number of queuing station/trunk
CONDITIONS
2nd Data=01
1≤N<2nd Data
(2nd Data≠01)
2nd Data≤N
(2nd Data≠01)
CM90 Assign the Overflowed UCD Call Indica-
tion LED to the required D
END
term
DESCRIPTION
term
.
term
is differ-
Steady on red irrespective of number of queuing station/trunk
Steady on red
Flashing red
term
.
UNIFORM CALL DISTRIBUTION (UCD)
for Overflowed UCD Call:
(1) 212
(2) 1 : Queuing
(1) 15
(2) 01-99: Number of queuing in each UCD
group
If no data is set, the default setting is 01.
LAMP INDICATION
Y=00
•
(1) My Line No. +
(2) F1280-F1295: UCD Group 0-15
– 550 –
DATA
,
+ Key No.
A2546-10