NEC NEAX 2000 Programming Manual page 228

A
Assign the necessary functions to the DTI
CMAA
card.
After entering the data, set the MB switch
on the DTI card to UP, and then to DOWN,
for DTI initialization.
The following table shows the re-
NOTE:
lationship between CMAA Y=01
and CMAA Y=02.
CMAA Y=01
(FRAME CON-
FIGURATION)
24-Multi Frame
[1]
12-Multi Frame
[0]
[ ]: Indicates 2nd data
CM30 Assign a trunk route number for tie line in-
terface to each DTI.
The DTI route must be separated
NOTE:
from any analog trunk route.
B
DESCRIPTION
DTI INITIAL
CMAA Y=02
(ZERO CODE
SIGNALING
SUPPRES-
SION)
B8ZS
Not available [1] Transparent
Available [0] B7
DIRECT DIGITAL INTERFACE (DDI)
Y=00 Data Mode
•
(1) 04-15, 20-31: AP No. assigned by
(2) 0: Based on AT&T Spec.
Y=01 Frame Configuration
•
(1) 04-15, 20-31: AP No. assigned by
(2) 0 : 12-Multi Frame
1 : 24-Multi Frame
Y=02 Zero Code Suppression
•
(1) 04-15, 20-31: AP No. assigned by
(2) 0 : Available
1 : Not available
Y=03
•
(1) 04-15, 20-31: AP No. assigned by
(2) 7 : Associated Channel Interoffice
Signaling
Y=00
•
(1) 000-255: Trunk No. assigned by CM07
(2) 00-63: Trunk Route No.
– 208 –
PROGRAMMING
24-DTI Assignment
DATA
CM05 Y=0
CM05 Y=0
CM05 Y=0
CM05 Y=0
Y=01
A2195-10