Trunk Access Code - NEC Univerge SV8100 Programming Manual

Issue 1.0
Level:
IN
Description
Use
The trunk access code can be set from 1~8 digits which is defined to type 3 and 4 in
Program 11-01. This is the code extension users dial to access Automatic Route
Selection. The Individual Trunk Access Code is used when Trunk Group Routing is
desired for an outgoing line.
Input Data
Item
2 - 88
Program 11 : System Numbering
Program 11-09 : Trunk Access Code
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you
must make the corresponding changes in Program 11-01.
Trunk Access
No. Code
01 Dial
(Up to four digits)

11-09 : Trunk Access Code

to assign the trunk access code (normally 9).
Caution!
Description
Use this program to
assign the trunk access
code (normally 9). This is
the code extension users
dial to access Automatic
Route Selection.
UNIVERGE SV8100
Default Related Program
9
11-01 : System
Numbering
14-01 : Basic Trunk
Data Setup
14-05 : Trunk
Group
14-06 : Trunk
Group Routing
21-02: Trunk Group
Routing for
Extensions
Program 11 : System Numbering