Toyota Tundra 2005 Service - Repair - Maintenance page 3671

C TROUBLESHOOTING
Reference:
10
3
0.2
1
Example:
Up
(Case 1)
Terminal Retainer
Terminal Retainer
[Retainer at Full Lock Position]
Stopper
[Retainer at Temporary Lock Position]
Example:
(Case 2)
14
1
(mm)
Tool
Terminal
Retainer
Secondary
Locking Device
2005 TOYOTA TUNDRA (EWD611U)
HOW TO REPLACE TERMINAL
(with terminal retainer or secondary locking device)
1. PREPARE THE SPECIAL TOOL
HINT : To remove the terminal from the connector, please
construct and use the special tool or like object shown on
the left.
2. DISCONNECT CONNECTOR
3. DISENGAGE THE SECONDARY LOCKING DEVICE OR
TERMINAL RETAINER.
(a) Locking device must be disengaged before the terminal
locking clip can be released and the terminal removed from
the connector.
(b) Use a special tool or the terminal pick to unlock the secondary
locking device or terminal retainer.
NOTICE:
Do not remove the terminal retainer from connector body.
[A] For Non-Waterproof Type Connector
HINT : The needle insertion position varies according to the
connector's shape (number of terminals etc.), so
check the position before inserting it.
"Case 1"
Raise the terminal retainer up to the temporary lock
position.
"Case 2"
Open the secondary locking device.