Keithley 4200A-SCS Reference Manual page 327

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Section 6: Clarius

If you change the Parameters, it will change the Column names, which can cause Formulator

functions to be erased. When using any of the tests or libraries supplied by Keithley Instruments,

leave the measurement option set to Cp-Gp.

You can select the following measurement options:

Z, Theta: Impedance and phase angle (degrees)

R+jX: Resistance and reactance

Cp-Gp: Parallel capacitance and conductance

Cs-Rs: Series capacitance and resistance

Cp-D: Parallel capacitance and dissipation factor

Cs-D: Series capacitance and dissipation factor

Param1 Column Name

The name that is used for parameter 1 in the Analyze sheet.

If you do not define a name, Clarius assigns a name. The assigned name is a combination of the

parameter name and the terminal label.

This cannot be left blank. If it is left blank, Clarius uses the previous value.

If you change the name, it is updated when the test is run. The results from earlier tests that are

available through Run History are not changed to the new name.

Param2 Column Name

The name that is used for parameter 2 in the Analyze sheet.

If you do not define a name, Clarius assigns a name. The assigned name is a combination of the

parameter name and the terminal label.

This cannot be left blank. If it is left blank, Clarius uses the previous value.

If you change the name, it is updated when the test is run. The results from earlier tests that are

available through Run History are not changed to the new name.

Report Test Conditions

If you select the Report Test Conditions option, the DC bias voltage and drive frequency values that

were used for the test are displayed on the Analyze sheet.

When this option is selected, column name fields are available. These are the names of the columns

in the Analyze sheet where this data is reported. You can change the names of the columns by

entering new values for DCV Column Name and Freq Column Name.

Model 4200A-SCS Parameter Analyzer Reference Manual

4200A-901-01 Rev. C / February 2017