Basic Configurations For The Device Management; Example For Configuring To Manage The S-Switch Through Telnet; Figure 1-3 Rear View Of The S5352C-Ei; Figure 1-4 Networking Diagram Of Managing S-Switch-A Through Telnet - Huawei Quidway S5300 Series Quick Start Manual

Quidway S5300 Series Ethernet Switches
Quick Start
Appearance of the S5352C-EI
The chassis of the S5352C-EI is 1 U high with the dimensions of 442.0 x 420.0 x 43.6 mm (width
x depth x

Figure 1-3 Rear view of the S5352C-EI

1.3 Basic Configurations for the Device Management

This section describes the basic configurations for the device management such as configuring
IP addresses, remote login, naming the device, and setting device time.

1.3.1 Example for Configuring to Manage the S-switch Through Telnet

1.3.1 Example for Configuring to Manage the S-switch Through
Telnet
Networking Requirements
As shown in
B are connected through a trunk link. To enable the network administrator to manage S-switch-
A remotely, you need to configure the Telnet service and set the device name on S-switch-A.
When the administrator logs in to S-switch-A through Telnet, ensure that the PC of the
administrator and S-switch-A are reachable at the network layer.

Figure 1-4 Networking diagram of managing S-switch-A through Telnet

RS-232
Issue 01 (2008-12-26)
height).Figure 1-3
Figure 1-4, S-switch-A is newly added to the network. S-switch-A and S-switch-
administrator
serial port
Console cable
PC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
shows the rear view of the S5352C-EI.
S-switch-C
Ethernet
S-switch-B
GE 0/0/24
Console port
GE 0/0/24
S-switch-A
1 Quick Start
1-3