Configuring Terminals; Logging In To The Device; Logging In To Device Through Telnet - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
Procedure
Step 1 Connect the COM port on the PC and the console port on the switch by a cable.
Step 2 Power on all devices to perform a self-check.
----End

1.2.3 Configuring Terminals

This part describes how to configure the terminal before login to the switch through the console
port.
Context
Do as follows on the PC:
Procedure
Step 1 Run the terminal emulation program on the PC, setting the communication parameters as
follows:
l Baud rate: 9600 bps
l Data bit: 8
l Stop bit: 1
l Parity: none
l Flow control: none
----End

1.2.4 Logging In to the Device

This part describes how to log in to the switch through the console port.
Context
Do as follows on the PC:
Procedure
Step 1 Press Enter until a command line prompt such as <Quidway> appears. Now the user view is
displayed for you to configure the switch.
----End

1.3 Logging In to Device Through Telnet

This section describes how to connect a terminal to a switch through Telnet to establish the
configuration environment.
Issue 01 (2011-07-15)
NOTE
If the AAA or Password authentication mode is configured for users to log in to the switch through the
console interface, the correct user name and password must be entered for a successful login.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Logging In to Switch
4