S9700 Core Routing Switch
Configuration Guide - SPU
1.2 Configuring a Service Type
When using an SPU, ensure that the service type of the SPU is the same as the type of the service
processed by the SPU. If the service type is not the required type, change the service type, and
then restart the SPU to make the change take effect.
1.2.1 Establishing the Configuration Task
This topic describes the pre-configuration task and data required for configuring a service type.
Applicable Environment
When using an SPU, select a service type. Currently, the SPU can process the following services:
l
l
l
l
Pre-configuration Tasks
Before configuring a service type for an SPU, log in to the SPU.
Data Preparation
To configure a service type for an SPU, you need the following data.
No.
1
1.2.2 Configuring a Service Type
The SPU can provide the firewall, NAT, IPSec and NetStream services to meet different service
requirements.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
set service-type type
The service type of the SPU is configured.
Issue 01 (2012-03-15)
Firewall
NAT
Load balancing
IPSec
Data
Number of the service type
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
3