Example For Configuring Nap-Based Remote Deployment In Static Mode - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
2.3.1 Example for Configuring NAP-based Remote Deployment in
Static Mode
In this example, the temporary neighbor relationship is set up between the switch and the device
with the empty configuration and IP addresses are assigned to the switch and the device to
implement remote deployment in manual mode.
Networking Requirements
As shown in
Switch B is the master device, and temporary neighbor relationship is to be set up between
Switch B and Switch C having an empty configuration. Switch B and Switch C need to be directly
connected via a single hop. Both the interfaces connecting Switch B and Switch C should be in
the Up state, and should support NAP.
Figure 2-1 Networking diagram of NAP-based remote deployment
PC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure a NAP master interface on Switch B
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] interface gigabitethernet0/0/1
[SwitchB-GigabitEthernet0/0/1] nap port master
Step 2 Configure an IP address for establishing a NAP connection on Switch B
Issue 01 (2011-07-15)
Figure 2-1, the user needs to perform a remote login to Switch B from Switch A.
SwitchA
Configure a NAP master interface on Switch B.
Configure an IP address for establishing a NAP connection on Switch B.
Use NAP to log in to Switch C from Switch B by means of Telnet.
Two primary IP addresses. The two IP addresses are primary IP addresses for the master
interface and the slave interface respectively, and should be on the same network segment.
Two secondary IP addresses. The two IP addresses are secondary IP addresses for the
master interface and the slave interface respectively, and should be on the same network
segment.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Network
SwitchB
2 NAP Configuration
SwitchC
20