Checking The Configuration; Configuration Examples; Example For Configuring Ipv4 Static Routes - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
ip route-static ip-address { mask | mask-length } { nexthop-address | interface-
type interface-number [ nexthop-address ] } [ preference preference | tag tag ]
track bfd-session cfg-name [ description text ]
A BFD session is bound to the IPv4 static route on the public network.
----End

1.5.5 Checking the Configuration

After BFD for static route is configured, you can check information about BFD sessions and
BFD for static route.
Prerequisites
BFD configurations for IPv4 static routes are complete.
Procedure
l
l
----End

1.6 Configuration Examples

This section provides configuration examples of static routes.

1.6.1 Example for Configuring IPv4 Static Routes

Networking Requirements
The PCs that belong to different network segments are connected through several switches. IPv4
static routes should be used so that any two PCs in different network segments can communicate
with each other.
Issue 01 (2012-03-15)
NOTE
When binding a static route to a BFD session, ensure that the static route resides on the same link as the
BFD session.
Run the display bfd session { all | discriminator discr-value } [ verbose ] command to
check BFD session information.
Run the display current-configuration | include bfd command to check the configuration
of BFD for static routes.
You can check information about a BFD session only after parameters for the BFD session
are set and the BFD session is established.
If BFD session negotiation succeeds, the status of the BFD session is displayed as Up. You
can also check that the BFD session is bound to the static route by running the display
current-configuration | include bfd command in the system view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Static Route Configuration
*
10