Example For Configuring The Lsp Ping Test For A Common Tunnel - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
6.27.11 Example for Configuring the LSP Ping Test for a Common
Tunnel
Networking Requirements
As shown in
l
l
l
The NQA LSP Ping test needs to be performed to check the connectivity of the LSP between
Switch A and Switch C.
Figure 6-13 Networking diagram for configuring the LSP Ping test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Issue 01 (2011-10-26)
port hybrid untagged vlan 110
#
nqa-server udpecho 10.2.1.2 9000
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
Figure 6-13:
The OSPF protocol runs on Switch A, Switch B, and Switch C. The three Switches learn
the 32-bit host routes on their loopback interfaces.
MPLS and MPLS LDP are enabled on Switch A, Switch B, and Switch C.
MPLS and MPLS LDP are enabled on VLANIF interfaces connected to Switch A,
Switch B, and Switch C to trigger the establishment of an LDP LSP.
Loopback1
1.1.1.9/32
GE0/0/1
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client.
Configure Switch C as the NQA server.
Create an LSP Ping test on Switch A.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
area 0
Loopback1
2.2.2.9/32
GE0/0/2
GE0/0/1
VLANIF110
10.2.1.1/24
SwitchB
6 NQA Configuration
Loopback1
3.3.3.9/32
GE0/0/2
VLANIF110
10.2.1.2/24
SwitchC
356