Operation Manual - STP
Quidway S6500 Series Ethernet Switches
2.3 BPDU Tunnel Configuration Example
I. Network requirements
The S6500 Series Ethernet Switches are used as the access devices of the
operator's network, that is, Switch C and Switch D in the following figure.
The S2000 Series Ethernet Switches are used as the access devices of the user
network, that is, Switch A and Switch B in the following figure.
Switch C and Switch D connect to each other through trunk port, enabling the
BPDU Tunnel function in system view, and implementing the transparent
transmission between user network and operator's network.
II. Networking diagram
Switch C
Switch C
Switch A
Switch A
Figure 2-2 Network diagram for BPDU Tunnel configuration
III. Configuration procedures
1)
Configure Switch A
# Enable RSTP on the device.
[Quidway] stp enable
# Add port Ethernet 0/1 into VLAN 10.
[Quidway] vlan 10
[Quidway-Vlan10] port Ethernet 0/1
2)
Configure Switch B
# Enable RSTP on the device.
[Quidway] stp enable
# Add port Ethernet 0/1 into VLAN 10.
[Quidway] vlan 10
[Quidway-Vlan10] port Ethernet 0/1
E 4/0/2
E 4/0/2
E 4/0/1
E 4/0/1
E 0/1
E 0/1
Huawei Technologies Proprietary
2-3
Chapter 2 BPDU Tunnel Configuration
E 3/0/1
E 3/0/1
Switch D
Switch D
E 3/0/2
E 3/0/2
E 0/1
E 0/1
Switch B
Switch B