Configuring Source Address For Radius Packets Sent By Nas - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Security
Quidway S6500 Series Ethernet Switches
authentication/authorization service is also used in these products and it is called local
RADIUS function, i.e. realize basic RADIUS function on the switch.
Perform the following commands in system view to create/delete local RADIUS
authentication server.
Table 2-31 Creating/deleting the local RADIUS authentication server
Create
authentication server
Delete
authentication server
By default, the IP address of local RADIUS authentication server is 127.0.0.1 and the
key is Huawei.
Caution
When using local RADIUS authentication server function of Huawei, remember the
number of UDP port used for authentication is 1645 and that for accounting is 1646.
The key configured by this command must be the same as that of the RADIUS
authentication/authorization
authentication in radius scheme view.

2.3.13 Configuring Source Address for RADIUS Packets Sent by NAS

Perform the following configurations in the corresponding view.
Table 2-32 Configuring source address for the RADIUS packets sent by the NAS
Configure the source address to be carried in the RADIUS
packets sent by the NAS (RADIUS scheme view).
Cancel the configured source address to be carried in the
RADIUS packets sent by the NAS (RADIUS scheme view).
Configure the source address to be carried in the RADIUS
packets sent by the NAS (System view).
Cancel the configured source address to be carried in the
RADIUS packets sent by the NAS (System view).
Operation
local RADIUS
local RADIUS
Operation
Huawei Technologies Proprietary
Chapter 2 AAA and RADIUS Protocol
Command
local-server nas-ip ip-address key string
undo local-server nas-ip ip-address
packet configured
2-23
Configuration
by the command
Command
nas-ip ip-address
undo nas-ip
radius nas-ip
ip-address
undo radius
nas-ip
key