Configuring The Lsa Transmission Delay - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S5600 Series Ethernet Switches-Release 1510
Set the dead time of the
neighboring
interface
Set the interval at which the
router retransmits an LSA to the
neighboring
interface
Note:
Default Hello and Dead timer values will be restored once the network type is
changed.
Do not set an LSA retransmission interval that is too short. Otherwise, unnecessary
retransmission will occur. LSA retransmission interval must be greater than the
round trip time of a packet between two routers.

4.7.3 Configuring the LSA transmission delay

Table 4-15 Configure the LSA transmission delay
Enter system view
Enter interface view
Configure the LSA transmission
delay
Operation
router on the
router on the
Operation
Huawei Technologies Proprietary
Command
ospf timer dead
seconds
ospf timer retransmit
interval
Command
system-view
interface
interface-type
interface-number
ospf trans-delay
seconds
4-21
Chapter 4 OSPF Configuration
Description
Optional
By default, the dead
time for the OSPF
neighboring router on
a p2p or broadcast
interface is
seconds and that for
the OSPF neighboring
router on a p2mp or
NBMA interface is 120
seconds.
Optional
By default, this interval
is five seconds.
Description
—
—
Optional
By default, the LSA
transmission delay is
one second.
40