Configuring The Delay For Transmitting Prune Messages In A Lan - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
l
----End
6.6.3 Configuring the Delay for Transmitting Prune Messages in a
LAN
The delay for transmitting Prune messages in a LAN can be set either globally or on an interface.
When the values of lan-delay on all devices along the same link are different, the maximum
value of these values is preferred.
Context
Do as follows on the PIM-DM switch:
Procedure
l
Issue 01 (2011-10-26)
The system view is displayed.
2. Run:
pim
The PIM view is displayed.
3. Run:
holdtime join-prune interval
The period during which the downstream interface is in the Prune state is set.
After the period expires, the pruned interface starts to forward packets again. Before
the period expires, the switch refreshes the Prune state when receiving a State-Refresh
message.
Configuration on an Interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
3. Run:
pim holdtime join-prune interval
The period during which the downstream interface is in the Prune state is set.
After the period is expired, the pruned interface starts to forward packets again.
Before the period expires, the switch refreshes the Prune state when receiving a State-
Refresh message.
Global Configuration
1. Run:
system-view
The system view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-DM (IPv4) Configuration
113