Configuring Control Parameters For Establishing The Neighbor Relationship - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
The switch can work normally by default. The S3700 allows the users to adjust the parameters
as required.
Pre-configuration Tasks
Before configuring control parameters for establishing the neighbor relationship, complete the
following tasks:
l
l
Data Preparation
To adjust the control parameters for establishing the neighbor relationship, you need the
following data.
No.
1
2
3
4
5
6
7.7.2 Configuring Control Parameters for Establishing the
Neighbor Relationship
The interval for sending Hello messages can be set either globally or on an interface. The
configuration in the interface view is prior to the configuration in the PIM view. When the
interval is not configured in the interface view, the configuration in the PIM view takes effect.
Context
Do as follows on the PIM-SM switch.
Issue 01 (2011-10-26)
NOTE
It is recommended to adopt the default value if there is no special requirement.
Configuring unicast routing protocol
Configuring Basic PIM-SM Functions
Data
Priority of the DR that is elected
Timeout period for waiting for Hello messages from a neighbor
Interval for sending Hello messages
Maximum delay for triggering Hello messages
DR switchover delay, that is, the period during which the original entries are still
valid when the interface changes from a DR to a non-DR.
Number or name of the ACL used to filter PIM neighbors
NOTE
The configuration involves the following cases:
l Global configuration: It is valid on all the interfaces.
l Configuration on an interface: The configuration on an interface takes precedence over the global
configuration. If the configuration on an interface is not done, the global configuration is used.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
157