Optional) Configuring The Anti-Jitter Time During Alarm Restoration; Optional) Configuring The Anti-Jitter Time During Alarm Generation - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
4.9.3 (Optional) Configuring the Anti-Jitter Time During Alarm
Restoration
By configuring the anti-jitter time during alarm restoration, you can suppress alarm flapping.
Context
Do as follows on each device:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm md md-name
The MD view is displayed.
Step 3 Run:
ma ma-name
The MA view is displayed.
Step 4 Run:
alarm finish time time
The anti-jitter time during alarm restoration is configured.
----End
4.9.4 (Optional) Configuring the Anti-Jitter Time During Alarm
Generation
By configuring the anti-jitter time during alarm restoration, you can suppress the alarm flapping.
Context
Do as follows on each device:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2011-10-26)
NOTE
IEEE 802.1ag has two versions, that is, IEEE 802.1ag Draft 7 and IEEE Standard 802.1ag-2007. The cfm
default md command can be used only on the device complying with IEEE Standard 802.1ag-2007. Before
using the cfm default md command, you must use the cfm version command to set the IEEE 802.1ag
version to IEEE Standard 802.1ag-2007.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Ethernet OAM Configuration
189