Configuring Forcible Fragmentation Of Outgoing Packets On An Interface; Setting Icmp Parameters - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The S9300&S9300E only checks the source IP addresses of the packets sent from the interface
to the CPU.
----End
6.3.3 Configuring Forcible Fragmentation of Outgoing Packets on
an Interface
Context
Do as follows on the S9300&S9300E.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created.
Step 3 Run:
quit
The system view is displayed.
Step 4 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 5 Run:
clear ip df
The interface is configured to delete the DF field.
By default, outgoing packets are not fragmented forcibly on an interface.
----End

6.3.4 Setting ICMP Parameters

Context
By default, the S9300&S9300E is enabled to send ICMP redirection packets and ICMP host
unreachable packets. The fast ICMP reply function is disabled on a S9300&S9300E.
Issue 01 (2012-03-15)
NOTE
The DF field is deleted from the packet sent from an interface; therefore, you need to configure this function
on an outgoing interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IP Performance Configuration
117