Creating A Vsi And Configuring Ldp Signaling - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
Data Preparation
To configure Martini VPLS, you need the following data.
No.
1
2
3
4

7.4.2 Creating a VSI and Configuring LDP Signaling

When using LDP as the PW signaling, you must configure the VSI ID for a VSI. VSI IDs
differentiate VSIs, and you can use these VSI IDs during PW signaling negotiation.
Context
Do as follows on the PEs of the two ends of the PW:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name static
A VSI is created and static member discovery mechanism is adopted.
Step 3 Run:
pwsignal ldp
The PW signaling protocol is specified as LDP and the VSI-LDP view is displayed.
Step 4 Run:
vsi-id vsi-id
The VSI ID is configured.
The VSI exists only on the PE. One PE can have multiple VSIs. One VPLS on a PE has only
one VSI.
Step 5 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
The VSI peer is configured.
Issue 01 (2011-07-15)
Data
VSI name
VSI ID
IP address of the peer and tunnel policy to establish the peer
Binding interface of the VSI
NOTE
The two ends of the VSI must agree on the same VSI ID.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 VPLS Configuration
692