Checking The Configuration; Configuring The Snmp Query Test - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
----End

6.10.3 Checking the Configuration

After configuring a traceroute test, you can view the test result.
Prerequisite
The configurations of the traceroute test are complete.
Context
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the statistics about each hop are displayed, it means
that the traceroute test is successful.
<Quidway> display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is trace
1 . Test 1 result

6.11 Configuring the SNMP Query Test

This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.
Issue 01 (2011-10-26)
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on the terminal. You need to run the display nqa
results command to view test results. By the default, the command output contains the records about only
the last five tests.
The test is finished
Completion:success
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Drop operation number:0
Last good path Time:2010-06-21 15:41:01.7
1 . Hop 1
Send operation times: 3
Min/Max/Average Completion Time: 1/2/1
Sum/Square-Sum Completion Time: 4/6
RTD OverThresholds number: 0
Last Good Probe Time: 2010-06-21 15:41:01.7
Destination ip address:10.112.58.3
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Attempts number:1
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Receive response times: 3
6 NQA Configuration
277