Ruijie Networks RG-S2600E Series Cli Reference Manual page 1032

S2600E CLI Reference Guide
6.2.3 diagnostic start
Use this command to start command line tests.
diagnostic start [slot slot_id [sub_system subsys_id]] test {all | test-id |
range test-range}
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Chapter 6 GRTD Configuration Commands
Parameter Description
slot slot_id Slot ID
(Optional) Subsystem ID (value range: 0-1), whose
sub_system
meaning is equivalent to cpu id in the show version
subsys_id
command.
test {all |
test-id | Test items. all means all items; range means a
range range, for example, from item m to item n.
test-range}
This command has no default setting.
Privileged mode
Use the diagnostic start command to start command line tests.

Generally, in command line tests, non-destructive tests are
conducted before destructive tests.

Store tests on a slot need to be conducted those on a
management board, because, after store tests on a
management board are conducted, the management board
needs to be reset to make the system be used normally.
Before command line tests
are started, you need to
stop
monitoring
Caution
planned tests about to be
conducted.
Example 1: The following example starts the tests for all test items
of slot 2.
system health
tests and