Format:status:extension - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:FORMat:STATus:EXTension

Syntax :FORMat:STATus:EXTension {ON|OFF|1|0}
:FORMat:STATus:EXTension?
Description This command enables/disables the status extension reporting for Contact
check failure.
If the status reported (numeric1) from *TRG,
(Detection of LowC or No Contact), then
enabled to find the source of Contact Check failure. The return value of status
determines the source of contact check failure and are as follows:
•
•
•
Parameter
ON or 1
OFF or 0
Query response {1|0}<newline><^END>
Related commands
*TRG
:FETCh?
:READ?
[:SENSe][:FIMPedance]:CONTact1:VERify[:STATe]
Equivalent key No equivalent key is available on the front panel.
224
+8: Threshold1 Failure
+16: Threshold2 Failure
+128: Signal Level Check failure when LVL COMP = ON and Contact Check
= ON.
Description
Enables the extended reporting of Contact Check Failure.
Disables the extended reporting of Contact Check Failure.
on page 163
on page 220
on page 230
:FETCh?
:FORMat:STATus:EXTension
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
and is 2
:READ?
can be
on page 260