Table of Contents
Advertisement
Reference Information
Miscellaneous Reference Information
When an unsupported calibration type is used, the CalPod software reports an
error during "Initialize Channel."
Setting a Static IP Address on the PNA (When Using USB 2.0 to LAN
Adapter)
When the CalPod Controller connects to the PNA via the USB 2.0 to LAN adapter,
sometimes it is necessary to manually set a Static IP address on the LAN interface.
Multiple installations of the CalPod Installation Package may require this
procedure.
1. Minimize the PNA application to access the desktop.
2. Click Start > Settings > Network Connections.
There should be two or more listings with the name "Local Area ConnectionsN"
(where N may be blank or an arbitrary character).
3. Right-click on the last item in the list and select Properties.
The listing under "Connect using:" should display "ASIX AX88772 USB2.0 to Fast
Ethernet."
If this text is not displayed, click Cancel and try another item in the list until this
device is found.
4. In the listing under "This connection uses the following items:", scroll down the
list and highlight "Internet Protocol (TCP/IP)."
5. Click Properties or double-click the item on the list.
6. Click "Use the following IP address."
7. Enter IP Address 192.168.0.1 with a Subnet Mask of 255.255.255.0. "Default
Gateway" can be left blank.
8. Leave the DNS settings blank.
9. Click OK as necessary to close the dialog windows. If you are presented with a
dialog window about entering a different IP address, click No.
10.Return to
test and verify that each CalPod is working.
Alternative Configuration for the LAN Cable (Not recommended)
If the USB 2.0 to LAN adapter is not available, the following LAN cable configuration
can be used. However, this configuration is not recommended because it does not
allow the PNA to communicate over the LAN with instruments other than the
controller.
85563-
"Step 9. Configure the CalPods" on page 1-14
and follow the steps to
Advertisement
Chapters
Table of Contents
