Calibration Settings - Keysight FieldFox B Series User Manual

NA (Network Analyzer) Mode
NA Mode Settings
How to view and change Quick Settings
— Press Meas Setup 4 > Settings.
— Press
— To change a setting:
— Press

Calibration Settings

NA Mode has a page specifically for making settings that pertain to Port
Extensions, including Velocity Factor and Media Type.
Learn more in
Learn more about Media Type in
See also,
Nearest (NA Mode Only)" on page
How to view and change Calibration Settings
— Press Meas Setup 4.
— Then
— Make these settings in the same manner as Quick Settings in the previous
Keysight N9938-90006 User's Guide
Next Page and Previous Page
are NOT available, then all available settings fit on one page.
—Use the arrows to highlight a setting.
—Then press Edit. The current setting changes to yellow.
—Some settings require you to press a softkey to change the value.
Otherwise, use the numeric keypad,
change the value.
—When finished changing a value, press
Dock Window to relocate the Settings table to a position relative to
the trace window. The Dock Window setting persists through a Preset.
Choose from the following:
—Full (Default setting) Only the Settings table is shown on the screen.
The trace window is temporarily not shown.
—Left The Settings table is shown to the left of the trace window.
—Bottom The Settings table is shown below the trace window.
When finished changing ALL settings, press
"Port Extensions" on page
Chapter 8 "Calibration for NA, CAT, and VVM Modes" and to
Calibration Settings
section.
to view all settings. If these softkeys
arrows, or rotary knob to
Done Edit.
Done to save your settings.
108.
"Waveguide Calibrations" on page
144.
140.
"Apply
97