Configuring Epipe Spoke Sdp Bindings; Figure 39: Sdps - Unidirectional Tunnels - Alcatel-Lucent 7705 Service Manual

Configuring VLL Components
The following example displays an Ethernet SAP-to-SAP configuration:
A:ALU-4>config>service# info
-------------------------------------
...
...
-------------------------------------

Configuring Epipe Spoke SDP Bindings

Figure 39
routers, identifying the service and customer IDs and the unidirectional SDPs required to
communicate to the far-end routers. The
sides.
An SDP must exist before it can be used with a spoke SDP. For SDP configuration
information, see
To configure a spoke SDP for ETH-CFM support, see
(802.1ag and Y.1731) on page
Page 210
epipe 2 customer 1 create
description "Ethernet sap2sap"
sap 1/1/1:1000
sap 1/2/1:50
no shutdown
exit
displays an example of a distributed Epipe service configuration between two
Figure 39: SDPs — Unidirectional Tunnels
ALU-1
Exit
SDP 2
Epipe 2 for
customer 6
Configuring SDPs on page
95.
sdp-id
spoke-sdp
Epipe 2 for
customer 6
SDP 3
Spoke-SDP 3
Exit
Spoke-SDP 2
92.
Configuring ETH-CFM Parameters
7705 SAR OS Services Guide
vc-id must match on both
:
ALU-2
19484