Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell Networking Operating System
(OS) on the S6000 platform.
This chapter contains the following sections:
•
Offline Diagnostic Commands
•
Buffer Tuning Commands
•
Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the
logging coredump server
Enable the platform to send application core dumps to an FTP server.
S6000
Syntax
logging coredump server {ftp-server | ip-address | ipv6-
address} username (ftp-username | name} password [type] {ftp-
password | password}
Parameters
ftp-server
ip-address
ipv6-address
name
ftp-username
type
500
Control and Monitoring
Enter the hostname or IP address of the FTP server where
Dell Networking OS sends application core dumps.
Enter the IP address of the target server in dotted decimal
format.
Enter an IPv6 address of the target server, in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter a username to access the target server.
Enter the user name to access the target ftp server.
Enter the password type:
•
Enter 0 to enter an un-encrypted password.
•
Enter 7 to enter a password that has already been
encrypted using a Type 7 hashing algorithm.
chapter.
Debugging and Diagnostics
13