Self Test - Sirona SIROLaser Xtend Operating Instructions Manual

5 Operation

5.3 Self Test

36
Self Test
5.3
After booting the SIROLaser Xtend will automatically perform a self test
including a status check of the following matters:
● Finger switch
● USB port
In addition, you will be informed when the next calibration check or
when the next servicing is due.
Finger switch
The self test of the finger switch may result into:
The finger switch is connected and the appropriate box will be marked
with a 'tick' for checked.
The finger switch is disconnected and the appropriate box will be
marked with a 'cross' for defect/missing.
NOTE
If the finger switch is marked 'cross' for defective/missing please
check if the handpiece sleeve is properly connected to the handpiece
body. If the problem remains please check the cable connection to
the SIROLaser Xtend control unit, see chapter "Troubleshooting of
simple defects". If the finger switch remains marked 'cross' for
defective/missing please contact your local dental depot or an
authorized Customer Service Department for technical support.
In general: If any switch is defective laser will be blocked.
USB port
To make sure that the USB port is available it is checked within the self
test.
The USB port can be 'tick' for checked or 'cross' for defective.
Sirona Dental Systems GmbH
Operating Instructions SIROLaser Xtend
63 18 351 D3576
D3576.201.01.05.02 11.2018