Interface Port-Channel - Dell C9000 Series Reference Manual

port-channel
number
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
Related
port-channel failover-group
Commands
configure a LAG failover group.
show interfaces port-channel
groups.

interface port-channel

Create a Port Channel interface, which is a link aggregation group (LAG) containing sixteen physical interfaces
on the switch.
C9000 Series
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number
command.
Parameters
channel-number
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series, E-Series, and S-Series.
— accesses PORT-CHANNEL FAILOVER-GROUP mode to
— displays information on configured Port Channel
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Interfaces 1020