Ipv6 Bgp Neighbor Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ipv6 bgp neighbor status

Enables or disables the BGP peer status. These peers are identified by their IPv6 addresses.
ipv6 bgp neighbor ipv6_address [status {enable | disable}]
Syntax Definitions
ipv6_address
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
You should first create a BGP peer and assign it an IPv6 address using the
command before enabling the peer.
•
You should configure all the BGP peer related commands before enabling a BGP peer. Once you have
enabled the peer, it will begin sending BGP connection and route advertisement messages.
Examples
-> ipv6 bgp neighbor 2001::1 status enable
-> ipv6 bgp neighbor 2001::1 status disable
Release History
Release 6.1.5; command was introduced.
Related Commands
show ipv6 bgp neighbors
MIB Objects
alaBgpPeer6Table
alaBgpPeer6Addr
alaBgpPeer6RowStatus
page 25-224
The 128-bit IPv6 address of the new BGP peer.
Enables the BGP peer.
Disables the BGP peer.
default
disable
Displays the configured IPv6 BGP peers.
ipv6 bgp neighbor
OmniSwitch CLI Reference Guide
BGP Commands
June 2012